Flow Control; Mirror - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1

Flow Control

This command enables flow control on this particular port.
Syntax
FSM726(config-if)# flow-ctrl
Help
The command displays instructions on how to access help on the CLI.
help
Syntax
FSM726(config-if)# Help
To access Help on a specific command, you enter a question mark behind the command in
question, then a list of available options will be presented to you. For example, suppose you want
to know the available options to the command . You would enter
cos cos ?.

Mirror

You can designate a port for monitoring traffic from one or more other ports or of a single VLAN
configured on the switch. The switch monitors the network activity by copying all traffic from the
specified monitoring sources to the designated monitoring port, to which a network analyzer can
be attached
Syntax
FSM726(config-if)# mirror [source | monitor]
Where
= Setting this particular port to be a mirror source or a mirror monitor
[source | monitor]
Use the no command to disable mirror.
Negotiation
This command lets you enable speed and duplex auto-negotiation.
Syntax
FSM726(config-if)# negotiation auto
Command Line Interface 6-17