Multimedia - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
= The Ethernet interface associated with the MAC address
<ethernet interface number>
you specified. The interface number is expressed in x/y format, where x is the stack number
(always 1 in the case with FSM726), and y is the port number.
Multicast-Static
You can use this menu to configure permanently reachable multicast groups. The
Static
command let you create individual groups by entering the MAC address of static
Multicast
group
Syntax
FSM726(config)# mac-address-table multicast-static <mac-address> ethernet <interface
number>
Where
= the MAC address you wish to place into the static multicast group.
<mac-address>
= the Ethernet interface associated with the static multicast group.
<interface number>
For example, if you want to add port 5 to static multicast group aa:aa:aa:10:30:3f, the command to
do so would be
FSM726(config)# mac-address-table multicast static aa:aa:aa:10:30:3f ethernet 1/5
Disable
The command disables the switch's dynamic address learning capability.
disable
Syntax
FSM726(config)# mac-address-table disable

Multimedia

In networks where multimedia applications generate multicast traffic, Internet Group Multicast
Protocol (IGMP) can greatly reduce unnecessary bandwidth usage by limiting traffic forwarding
that is otherwise broadcast to the whole network to only those ports that need it. Enabling IGMP
will allow the switch to detect IGMP queries, report packets, and manage IP multicast traffic
through the switch.
6-22 Command Line Interface