Advanced> Vlan> Vlan Ports - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
Add a port to a VLAN Group:
Under the 'Show VLAN' drop down menu, select the VLAN you want to edit.
1.
Click the box below the port number on the line of the VLAN so that a 'T' (tagged) or 'U'
2.
(untagged) appears.
Click Apply.
3.
Remove a port from a VLAN Group:
Click the box again until a blank box appears. This will remove VLAN membership from the
1.
port.
Click Apply.
2.
Advanced> VLAN> VLAN Ports
Figure 5-35: VLAN Port Settings
All untagged packets entering the switch will by default be tagged with the ID specified by the
port's PVID. This screen allows you to specify the PVID for each port. The number next to each
port indicates which PVID is set for each port. Following industry standards, PVID 1 is the default
PVID.
5-34 Web-Based Management Interface