Mac-Address-Table - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
= removing this particular port from a trunk. The trunk number ranges from
remove <trunk #>
1-4.
For example, to add this particular port to trunk 4 by entering
FSM726(config-if)# trunking add 4
By the same token, to remove this port from trunk 4, you would enter
FSM726(config-if)# trunking remove 4

Mac-address-table

The command lets you configure the operation and maintenance of the
mac-address-table
MAC address table. The aging timers and static entries are configured through this command.
Aging-Timer
Syntax
FSM726(config)# mac-address-table aging-timer <aging time>
Where
= the maximum time where a MAC address will stay in the MAC address table.
<aging time>
This number ranges from 10-1,000,000 seconds.
Static
The Static Addresses Table, allows the administrator to specify Media Access Control (MAC)
addresses for specific ports that will not be purged from the bridge table by the aging function.
Syntax
FSM726(config)# mac-address-table static <mac-address> <ethernet interface number>
Where
= The MAC address you wish to keep on the table regardless of aging timers.
<mac-address>
The MAC address is a 48-bit string, expressed in hexadecimal with a colon separating every 8 bits.
For example, 00:2d:3f:22:11:54.
Command Line Interface 6-21