Introduction To The Command Menu Interface - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

When the following screen appears, make sure that the port setting are as follows:
4.
Baud Rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
Figure 4-4: Connection Settings
Click OK.
5.
The HyperTerminal window will open and you should be connected to the switch. If you do not
see the welcome screen or a system menu, press the return key.
In order to use the arrow keys when attached to the User Interface via a Telnet Session, make sure
the VT100 Arrows option is turned on. Under the terminal pull-down menu, choose Properties to
set this option.

Introduction to the Command Menu Interface

The switch offers a Command Menu Interface (CMI), which is a menu-driven method for
managing the switch, as well as a Command Line Interface (CLI), which uses text inputs to
manage the switch. The CLI is accessed through the CMI, but is not addressed in this chapter.
Chapter 6 discusses the CLI in detail.
Administration Console Telnet Interface
9600
8
None
1
None
700 Series Software Manual v2.1
4-3