Set-Up> Port Configuration - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
Click Apply to change the IP settings
Save Configuration to NVRAM and reset the system to implement the changes (Tools > Save
Configuration).
Set-up> Port Configuration
Figure 5-14: Port Configuration
This menu allows you can configure the status of each port.
• Port:
• Name:
• Link:
• On/Off:
• State:
• Speed:
5-14
The port number on the switch
The name of the port. This is a user-defined label.
A green triangle pointing up indicates a valid link, while a red triangle
pointing down indicates no link.
Indicates if the port is enabled or disabled by the Administrator.
This refers to the Spanning Tree state of the port. Ports will be Blocking
(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled
(Dis).
Indicates the speed and duplex for the port. The possible entries are
Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full
duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full
duplex (100M Full).
Web-Based Management Interface