NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual page 116

700 Series Software Manual v2.1
Syntax.
FSM726(config)# snmp server community <name> [ro | rw |wo | trap]
Where
= the name of the community
<name>
[ro | rw |wo |trap]
= read only.
ro
= read-write access
rw
= read-only
wo
= trap allowed
trap
Contact
You can use the contact command to specify contact information for the switch.
Syntax
FSM726(config)# snmp-server contact <contact info>
Where
= the contact information associated with this switch.
<contact info>
Location
You can use the
location
Syntax
FSM726(config)# snmp-server location <location info>
Where
<location info>
Name
Use the command to give a name to the switch. This is done to make the switch easier to
name
identify.
Syntax
6-24
= the privilege associated with this community.
command to describe the location of the switch.
= the location of this switch.
Command Line Interface