700 Series Software Manual v2.1
Syntax
FSM726(config)# system gateway <default gateway>
Where
<default gateway>
Save
The
command is used to save the configuration to NVRAM once you have made changes.
save
Syntax
FSM726(config)# system save
Restore
The
command is used to restore all configurations back to factory default value. Please
restore
note that this command will cause the switch to reset itself.
Syntax
FSM726(config)# system restore
Web
Use this command enable/disable the web configuration interface. Use the
the web interface.
Syntax
FSM726(config)# system web
Telnet
Use this command to enable/disable configuration via telnet. Use the
Telnet access.
Syntax
FSM726(config)# system telnet
6-30
= the IP address of the default gateway
command to disable
No
command to disable the
No
Command Line Interface