Username; Password; Firmware Boot - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

Username

Use the
username
Syntax
FSM726(config)# system username <username>
Where
= the user name you wish to set up for accessing the switch. Please note that this
<username>
field is case sensitive.

Password

Use this command to set a password for the switch
Syntax
FSM726(config)# system password <password>
Where
= the password you wish to set for the switch.
<password>

Firmware boot

The firmware command is used to upgrade the firmware through a variety of options. The
command is used to configure the way in which the switch will boot after a firmware upgrade.
Once the IP address of the TFTP and the path location of the new software image file is properly
configured (Please see section 17 & 18), the user can choose one of three options to boot the
switch after the firmware has been upgraded.
• Net option:
This option allows you to try out a new image before upgrading. It requires a TFTP filename
and a server IP address to retrieve the specified image from the given IP address.
The new image will not overwrite the one in non-volatile memory.
• Net & save option
This option requires the same setup as the Net option, i.e. TFTP server and a new image.
However, it copies the image to non-volatile memory directly and then the system boots from
non-volatile memory
Command Line Interface
command to create a new user for the switch.
700 Series Software Manual v2.1
boot
6-31