Exit; Interface - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

Exit

The command takes you out of the CLI mode by one level. For example, when you are in
exit
configuration mode, and the prompt looks like
prompt, you will exit the configuration mode and be taken back to the root level, where the prompt
.
looks like
FSM726#
Main Menu of the switch.
Syntax
FSM726(config)# exit

Interface

The command allows you to configure each network interface of the switch. Items
interface
such as the speed, duplex, and negotiation are configured in this mode. The command to enter the
interface mode is
Syntax
FSM726(config)# interface ethernet <x/y>
Where
=
x is the stack number, and y is the port number, which ranges from 1-26. Since FSM726
<x/y>
is not stackable, the value of x is always 1.
For example, suppose you want to configure port 8 on the switch, the command to do so would be:
FSM726(config)# interface ethernet 1/8
When the interface command is properly entered, you will be taken to the Interface Configuration
Mode, where the prompt changes from
When you are done configuring one particular interface and wish to configure another interface,
you must exit the Interface Configuration Mode by using the
re-enter Interface Configuration Mode by specifying another interface, again, using the
command
interface
When you're in interface configuration mode, you will be able to configure the following items.
Command Line Interface
When you enter the
exit
FSM726(config)#
700 Series Software Manual v2.1
.
FSM726(config)#
command at the root level, you will return to the
to
FSM726(config-if)#.
command. You then have to
exit
By entering at the
exit
6-15