Reset - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

Syntax
FSM726(config)# system radius authen-mode [local | local-then-remote | remote]
Where
= authentication is performed locally and not through an external RADIUS server
Local
Local-then-remote
server
= Authentication is performed by a remote server and not locally.
Remote
• Server-IP
The
Server-IP
Syntax
FSM726(config)# system radius server-ip <IP-address>
Where
= IP address of the RADIUS server
<IP address>
• Shared-Secret
The
shared-secret
Syntax
FSM726(config)# system radius shared-secret <shared secret>
Where
<shared secret>

Reset

Use the reset command to reboot the switch.
Syntax
FSM726(config)# system reset
Command Line Interface
= Authentication is performed locally first, then by an external RADIUS
command is used to set the IP address of the RADIUS server
command lets you set the RADIUS shared secret
= the RADIUS shared secret
700 Series Software Manual v2.1
6-33