Configure And Enable Call-Home Features; Configure And Enable Ethernet Events; Configure Threshold Alerts; Configure Ethernet Events Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Configure and Enable Call-Home Features

There are two call-home features available, and only one is installed when the
HAFM application is installed on the HAFM server. To learn more about
configuring Call-Home features, refer to the HAFM server installation guide.

Configure and Enable Ethernet Events

Perform this procedure to configure and enable Ethernet events. An Ethernet event
is recorded (after a user-specified time interval) when the Director-to-HAFM
Server communication link drops. To configure and enable Ethernet events:
1. Choose Maintenance > Configure Ethernet Events. The Configure
Figure 20: Configure Ethernet Events Dialog Box
2. Click the Enable Ethernet Events check box. A check mark displays in the
3. Type a value between 10 through 120 minutes in the Ethernet Timeout field.
4. Click OK to close the dialog box.

Configure Threshold Alerts

A threshold alert notifies users when the transmit (Tx) or receive (Rx) throughput
reaches specified values for specific switch ports or port types, (E_Ports or
F_Ports).
You are notified of a threshold alert in four ways:
Edge Switch 2/24 Installation Guide
Ethernet Events dialog box displays, as shown in
check box to indicate Ethernet events are enabled.
A yellow triangle that displays on the port in the Port Card View.
A yellow triangle that displays on the port in the Hardware View.
A yellow triangle that displays in the Alert column of the Port List View.
A yellow triangle that displays by the Threshold Alerts field in the Port
Properties dialog box.
Detailed threshold alert data recorded in the Threshold Alert Log.
Installing and Configuring the Edge Switch 2/24
Figure 20.
65