Rack-Mount Installation - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

3. Verify all field-replaceable units (FRUs), including small form factor
4. Connect the U.S. or country-specific (optional) AC power cords to the right
5. Connect the remaining ends of the AC power cords to separate facility power
6. After successful POST completion, the green power (PWR) LED remains
7. If a POST error or other malfunction occurs, refer to the HP StorageWorks

Rack-Mount Installation

To install the Edge Switch in a customer-supplied equipment rack, refer to the HP
StorageWorks Edge Switch 2/24 Rack Mount Kit Installation Instructions included
with the Edge Switch hardware.
Edge Switch 2/24 Installation Guide
pluggable (SFP) optical transceivers and combined cooling fan and power
supply assemblies are installed as ordered.
(PS0) and left (PS1) receptacles at the rear of the chassis.
WARNING: An HP-supplied power cord is provided for each Edge Switch
power supply. To prevent electric shock when connecting the Edge Switch to
primary facility power, use only the supplied power cords, and ensure the
facility power receptacle is the correct type, supplies the required voltage, and
is properly grounded.
sources that provide single-phase, 90 to 264 volt alternating current (VAC)
current. This provides power redundancy.
When the first power cord is connected, the Edge Switch powers on and
performs power-on self-tests (POSTs). During POSTs:
a. The green power (PWR) LED on the front panel illuminates.
b. The amber system error (ERR) LED on the front panel blinks
momentarily while the Edge Switch is tested.
c. The green LEDs associated with the Ethernet port blink momentarily
while the port is tested.
d. The green/blue and amber LEDs associated with Fibre Channel ports
blink momentarily while the ports are tested.
ON and all other front panel LEDs turn OFF.
Edge Switch 2/24 Service Manual to isolate the problem.
Installing and Configuring the Edge Switch 2/24
39