Lan-Connect The Switch - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

LAN-Connect the Switch

Connect the switch to the customer-supplied Ethernet LAN segment or the
HP-supplied Ethernet hub.
To connect the desktop or rack-mounted switch to the Ethernet LAN segment:
1. Connect one end of the Ethernet patch cable (supplied with the switch) to the
2. Connect the remaining end of the Ethernet cable to the LAN as follows:
3. Perform one of the following steps:
Edge Switch 2/24 Installation Guide
RJ-45 connector (labeled 10/100) on the left front of the chassis.
a. If the switch is installed on a customer-supplied LAN segment, connect
the cable to the LAN as directed by the customer's network administrator.
b. If the switch is installed on the HP-supplied Ethernet hub, connect the
cable to any available port on the hub.
If an HAFM server or customer-supplied server platform is delivered and
available, the Ethernet LAN segment does not require connection to the
internet. Go to "HAFM
If an HAFM server is not available and the switch is managed through the
EWS interface, attach the Ethernet LAN segment to an internet
connection and go to
Installing and Configuring the Edge Switch 2/24
Server" on page 46.
Chapter 3, Using the Embedded Web Server.
45