Using the Embedded Web Server
Enable or Disable the CLI
Perform this procedure to toggle (enable or disable) the state of the switch's
command line interface. To change the CLI state:
1. At the Configure window, click the CLI tab. The Management page displays
Figure 40: Management page—CLI tab
2. Perform one of the following steps as required:
98
with the CLI tab selected, as shown in
— Click Enable to activate the CLI. The message "Your changes to
the CLI enable state have been successfully
activated" displays.
— Click Disable to deactivate the CLI. The message "Your changes to
the CLI enable state have been successfully
activated" displays.
Figure
40.
Edge Switch 2/24 Installation Guide