Modify Alerts; Activate Or Deactivate Alerts - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Modify Alerts

Use the following steps to modify an existing threshold alert configuration.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
2. If the alert is active, click Deactivate, then choose the alert information in the
3. Click Modify. An initial Modify Threshold screen displays where you can
4. Select a threshold type from the drop-down list.
5. Click Next when you are done. A Modify Threshold screen displays where
6. Make appropriate changes, then continue through the Modify Threshold
7. Perform either of the following steps:

Activate or Deactivate Alerts

Use the following steps to activate or deactivate existing threshold alerts. In the
active state, notifications are generated for the alert. In the inactive state,
notifications do not occur.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
2. To change the state, choose the alert by the alert information in the table.
3. If the alert is active, choose Deactivate to change to the inactive state. If the
Edge Switch 2/24 Installation Guide
Configure Threshold Alerts dialog box displays.
Select the alert that you want to modify by clicking the alert information in the
table. If the alert is active, an error message displays prompting you to
deactivate the alert.
table again.
change the threshold type.
you can change the % utilization, cumulative minutes for the threshold to
occur before notification, and the time interval for measuring throughput and
for alert notification.
screens, making changes as necessary, until the summary screen displays the
alert configuration.
If you need to change any parameters, click Previous or Next to display
the desired Modify Threshold screen.
Click Finish when you are done.
Configure Threshold Alerts dialog box displays.
The port's current state, inactive or active, is listed under the State column.
alert is inactive, choose Activate to change to the active state.
Installing and Configuring the Edge Switch 2/24
71