Connection Description Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Perform the following steps to change a switch's IP address, subnet mask, or
gateway address:
1. Remove the protective metal plate from the 9-pin maintenance port at the rear
2. Connect the other cable end to a 9-pin communication port (COM1 or
3. Power on the maintenance terminal. After the PC powers on, the Windows
Note:
communication software are described in
4. Choose Start > Programs > Accessories > Communications >
Figure 5: Connection Description dialog box
Edge Switch 2/24 Installation Guide
Note that the HAFM server may be used for this function and that
HyperTerminal is included in Windows 2000 provided in the HAFM server.
An asynchronous RS-232 null modem cable (provided with the switch).
of the switch (a phillips-tip screwdriver is required). Connect the 9-pin end of
the RS-232 null modem cable to the port.
COM2) at the rear of the maintenance terminal PC.
desktop displays. Refer to operating instructions shipped with the PC.
Procedures for changing network addresses using the HyperTerminal serial
HyperTerminal. The Connection Description dialog box displays,
(Figure 5).
Installing and Configuring the Edge Switch 2/24
step 4-step 13.
41