Disconnect Now Dialog Box; Save Session Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Installing and Configuring the Edge Switch 2/24
10. Change the IP address, subnet mask, and gateway address as directed by the
11. Choose Exit from the File menu to close the HyperTerminal application. A
Figure 9: Disconnect Now dialog box
12. Click Yes. A message box displays
Figure 10: Save Session dialog box
13. Click No to exit and close the HyperTerminal application.
14. Power off the maintenance terminal:
15. Disconnect the RS-232 null modem cable from the switch and the
44
customer's network administrator. To change switch network addresses, type
the following at the C> prompt and press Enter.
ipconfig xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz
The IP address is always xxx.xxx.xxx.xxx, the subnet mask is always
yyy.yyy.yyy.yyy, and the gateway address is always zzz.zzz.zzz.zzz, where
the octets xxx, yyy, and zzz are decimals from zero through 255. If a network
address is to remain unchanged, type the current address in the respective
field.
When the new network addresses are configured at the switch, the message
Request completed OK displays at the bottom of the
Edge Switch 2/24 — HyperTerminal window.
message box displays
a. Choose Start > Shut Down. The Shut Down Windows dialog box
displays.
b. At the Shut Down Windows dialog box, choose Shut down the
Computer and click Yes to power off the PC.
maintenance terminal. Replace the protective plate over the maintenance port.
(Figure 9).
(Figure 10).
Edge Switch 2/24 Installation Guide