Switch Page-Network Tab; Network Configuration Changes Activated - HP 316095-B21 - StorageWorks Edge Switch 2/24 Installation Manual

Using the Embedded Web Server
Figure 37: Switch page—Network tab
3. Click Activate to save the information. The following message box displays,
Figure 38: Network configuration changes activated
4. Update the address resolution protocol (ARP) table for the browser PC.
5. At the PC, launch the browser application (Netscape Navigator or Internet
94
a. At the IP Address field, type the new value as specified by the customer's
network administrator (default is 10.1.1.10, factory preset is 10.1.1.10).
b. At the Subnet Mask field, type the new value as specified by the
customer's network administrator (default is 255.0.0.0).
c. At the Gateway Address field, type the new value as specified by the
customer's network administrator (default is 0.0.0.0).
as shown in Figure 38.
a. Choose File > Exit to close the embedded web server and browser
applications. The Windows desktop displays.
b. Choose Start > Programs > Command Prompt. A disk operating
system (DOS) window displays.
c. Delete the switch's old IP address from the ARP table. At the command
(C:\) prompt, type arp -d xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the old IP address for the switch.
d. Click close (X) at the upper right corner of the DOS window to close the
window or enter exit at the prompt to return to the Windows desktop.
Explorer).
Edge Switch 2/24 Installation Guide