HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 175

Message
Cannot disable Fabric
Binding while
Enterprise Fabric Mode
is active.
Cannot display route on
a one switch fabric.
Cannot display route.
All switches in route
must be managed by
the same server.
Cannot display route.
All switches in route
must support routing.
Cannot display route.
Device is not a member
of a zone in the active
zone set.
Cannot display route.
Error 9.
Cannot display route.
No active zone
enabled.
ha-fabric manager user guide
Description
You attempted to disable
Fabric Binding through the
Fabric Binding dialog box,
but Enterprise Fabric Mode
was enabled.
You cannot show routes
between end devices in a
fabric when configuring
Show Routes (Fabrics
menu).
You cannot show the route
between devices that are
attached to Switches or
Directors managed by a
different HAFM server.
You cannot show the route
through a fabric that has
Switches or Directors which
do not support routing.
You cannot show the route
for a device that is not a
member of a zone in the
active zone set. The source
node that you have selected
is not part of a zone in the
active zone set.
An internal error has
occurred while you were
trying to view routes.
You cannot show the route
through a fabric with no
active zone.
Information and Error Messages
Action
Disable Enterprise Fabric
Mode through the
Enterprise Fabric Mode
dialog box in HAFM
before disabling Fabric
Binding.
Error displays when
attempting to show
routes on a fabric with
only one Switch.
Configure the Show
Route option on a
multiswitch fabric.
Make sure devices
named in Show Routes
dialog box are attached
to products managed by
this HAFM server.
The route must contain
Edge Switch 2/
only
Edge Switch 2/
32
Switches or Director 2/64
directors.
Enable the default zone
or activate the zone for
the device before
attempting to show the
route.
Contact the next level of
support to report the
problem.
Enable the default zone
or activate a zone set
before attempting to
show the route.
16,
A–3