Snmp Agent; Configure Snmp Dialog Box - HP 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

Ha-fabric manager user guide
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

SNMP Agent

Choose the SNMP Agent option to open the Configure SNMP dialog box that allows
you to configure the SNMP agent that runs on the HAFM server and implements the
Fibre Alliance MIB.
The HAFM server software contains a simple network management protocol (SNMP)
agent component. The HAFM SNMP agent instruments the objects defined in the
Fibre Channel Management (FCMGMT) Management Information Base (MIB)
Version 2.2 and a small number of objects defined in MIB II. Through instrumentation
of these MIB objects, the agent acts as a translator of information stored on the HAFM
server and attached Directors into a form usable by SNMP management stations such
as HP OpenView. Refer to the hp StorageWorks SNMP reference guide for directors
and edge switches.
Use these steps to configure the SNMP agent that runs on the HAFM server and
implements the Fibre Alliance MIB.
You can configure network addresses and community names for up to 12 SNMP trap
recipients, which receive messages through SNMP for specific events that occur on
the HAFM server.
When configuring SNMP, you can configure just the community names of valid
SNMP management stations. In this case, you do not need to fill in the Trap
Recipient column or the UDP Port Number column.
To configure and enable SNMP traps, use the following steps:
1. Choose Configure > SNMP Agent.
The Configure SNMP dialog box displays
Figure 3–10: Configure SNMP dialog box
ha-fabric manager user guide
Using the Menu Bar
(Figure
3–10).
3–19

Advertisement

Table of Contents
loading

Table of Contents