Unpacking And Setting Up The Printer - IBM 4332-004 - InfoPrint 40 B/W Laser Printer User Manual

__ 10. Install print drivers and configure your host environment. See
__ 11. Get familiar with your printer. See "Chapter 3. Using the Operator

Unpacking and Setting Up the Printer

Before you install your printer, make sure you have a place large enough to
put it. Without any of its optional features attached, the printer dimensions
are:
v Width: 28 inches (762 mm)
v Depth: 20.5 inches (520 mm)
v Height: 19.1 inches (486 mm)
In addition, make sure you leave enough room around the printer to access
and operate it. For the standard configuration with no options, IBM
recommends leaving at least 7.8 inches (200 mm) in the back of the printer,
18.1 inches (460 mm) in the front of the printer, 7.8 inches (200 mm) on the
right side, and 25.2 inches (640 mm) on the left side of the printer.
When options are installed, IBM recommends leaving at least 7.8 inches (200
mm) in the back of the printer, 18.1 inches (460 mm) in the front of the
printer, 39.4 inches (1000 mm) on the right side, and 25.2 inches (640 mm) on
12
Infoprint 32 and Infoprint 40: User's Guide
"Installing Printer Drivers" on page 20.
Panel" on page 21.