Table of Contents
Advertisement
862 CX SEND STATE
871 NETWORK OPT / RESEAT OPTION
872 NETWORK OPT / RESEAT OPTION
876 NETWORK OPT / CHECK CONFIG
262
Infoprint 32 and Infoprint 40: User's Guide
Setup Menu, or (b) the printer has been in an intervention required
state (such as, out of paper) for longer that the IRQ TMEOUT setting.
Action: Solve the problem that caused the message (for example, press
the Online key to put the printer online, or add paper). To disable
this error message, set the HLD TMEOUT and IRQ TMEOUT values
in the Coax Setup Menu to 0.
Meaning: Your coax host has placed your printer in "Send State" and
is waiting for the printer to return a PA signal.
Action: Press the Continue key to clear the message. (You may need
to press the key more than once.) Then do the following to send the
PA signal.
1. Press the Online key to take the printer offline.
2. Press the Menu key until you see the Coaxial SCS Menu.
3. Press the Item key until you see PA1 or PA2 (whichever signal
you want to send).
4. Press the Enter key to send the signal.
5. Press the Online key to resume printing.
Meaning: The printer detected a network interface card in the right
slot, but the card is not communicating.
Action: Make sure the network interface card is properly installed and
restart the printer. See "Installing a Network Interface Card" on
page 172. If the message recurs, call for service. Remove the network
interface card from the printer if you want to print a printer
configuration page or if you want to print from the parallel port.
Meaning: The printer detected a network interface card in the left
slot, but the card is not communicating.
Action: Make sure the network interface card is properly installed and
restart the printer. See "Installing a Network Interface Card" on
page 172. If the message recurs, call for service. Remove the network
interface card from the printer if you want to print a printer
configuration page or if you want to print from the parallel port.
Meaning: The printer has detected that two of the same network
interface cards have been installed.
Action: Remove one of the cards.
Advertisement
Table of Contents
