Table of Contents
Advertisement
Chapter 8. Installing Printer Options
This chapter describes how to install and remove the following options:
v The SIMM and hard drive (see page 166)
v Network interface cards (see page 172)
v The Face-Up Output Bin (see page 175)
v The 2500-Sheet Input Unit (see page 181)
v The Envelope Feeder (see page 188)
v The 2000-Sheet Finisher (see page 191)
v The Duplex Unit (see page 206)
To verify that an option is installed correctly, print the configuration
page. See "Printing the Printer Configuration Page" on page 25. Also,
make sure you update your printer driver to indicate the new feature is
installed.
Handling Static Sensitive Devices
When you handle options and other computer components, take these
precautions:
v Limit your movement. Movement can cause static electricity to build up
around you.
v Always handle components carefully. Handle adapters and memory-module
kits by the edges. Never touch any exposed circuitry.
v When you are installing a new option, touch the static-protective package
containing the option to the mounting bracket on the controller card for at
least two seconds. This reduces static electricity from the package and from
your body.
v When possible, remove the option and install it directly in the controller
without setting the option down. When this is not possible, place the
static-protective package that the option came in on a smooth, level surface
and place the option on it.
v Do not place the option on the printer cover or other metal surface.
© Copyright IBM Corp. 1998, 1999
Important!
165
Advertisement
Table of Contents
