Memory Requirements - IBM 4332-004 - InfoPrint 40 B/W Laser Printer User Manual

v Norway: 800-11389
v Spain: 900-983131
v Sweden: 020-794270
v United Kingdom: 0800-968679
The following table lists supplies for the Infoprint 32 and Infoprint 40. See
"Chapter 7. Maintaining the Printer" on page 143 for more information.
Supply
Toner Cartridge
Usage Kit (100 Volt) (Japan only)
Usage Kit (120 Volt)
Usage Kit (230 Volt)
Staple Refill
Staple Cartridge (with staples)

Memory Requirements

Table 1 on page 9 shows the minimum memory requirements for Infoprint 32
and Infoprint 40.
Notes:
1. The PAGEPROT menu item is available on the PCL Menu, the PostScript
(PS) Menu, and the IPDS Menu. It determines whether or not the printer
uses compression when it prints complex pages.
v PAGEPROT=AUTO—the printer uses compression when it runs into
v PAGEPROT=ON—the printer does not use compression and therefore
2. When a column contains two values, the second value indicates the
amount of memory required to support context saving. Context saving
allows the printer to remember information about the current data stream
when it switches back and forth from one job type (PostScript or PCL5e)
to another. The printer always does context saving for IPDS.
The Memory Configuration (MEMCONFIG) Menu provides two menu
items, PCL SAVE and PS SAVE, which allow you to set context saving on
or off for each of these two data streams. These menu items are displayed
only if there is enough memory in the printer to permit context saving.
3. If you use Japanese DBCS (double-byte character set) PostScript fonts, IBM
recommends that you have at least 16MB of memory.
8
Infoprint 32 and Infoprint 40: User's Guide
memory constraints. This can reduce print speed and requires less
memory than PAGEPROT=ON.
requires more memory.
Part Number
90H3566
90H3569
90H3567
90H3568
90H3570
90H3571