Table of Contents
Advertisement
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that is now active.
2. This menu appears only when you have the IPDS option installed.
3. If you are unfamiliar with using the operator panel to work with menus,
please read "Using the Operator Panel Keys" on page 23 and "Navigating
Menus" on page 24 before continuing.
4. See "Defining Custom Form Sizes for IPDS" on page 68 for an example of
defining a custom form.
5. Custom forms can only be fed from the auxiliary tray.
Custom Forms
Menu Item
FORM1 UNITS
FORM1LEN
FORM1WIDTH
FORM2 UNITS
FORM2LEN
FORM2WIDTH
FORM3 UNITS
FORM3LEN
FORM3WIDTH
FORM4 UNITS
FORM4LEN
FORM4WIDTH
FORM5 UNITS
FORM5LEN
FORM5WIDTH
Configuration (Config) Menu
Use the Configuration Menu to configure the printer. The following table
describes the settings you can change from the Configuration Menu. An
asterisk (*) next to a value in the table indicates the factory default.
102
Infoprint 32 and Infoprint 40: User's Guide
Value
mm*
in
nnn
nn.n
nnn
nn.n
Specifies the unit of measurement for the custom form.
Specifies the length of the custom form. If FORM UNITS is
set to millimeters, acceptable values are 99 to 432
millimeters. If FORM UNITS is set to inches, acceptable
values are 3.9 to 17.0 inches.
Specifies the width of the custom form. If FORM UNITS is
set to millimeters, acceptable values are 100 to 297
millimeters. If FORM UNITS is set to inches, acceptable
values are 3.9 to 11.7 inches.
Specifies up to four more custom forms. See FORM1
UNITS, FORM1LEN, and FORM1WIDTH for a description
of each field.
Description
Advertisement
Table of Contents
