Table of Contents
Advertisement
Twinax Setup
Menu Item
SCS ADDR
IPDS ADDR
EDGE-EDGE
Value
OFF*
The twinax hardware address of the SCS port. n can be
n
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
2. If you change SCS ADDR or IPDS ADDR, you must
3. When the IPDS SIMM is installed, the printer can act as
OFF*
The twinax hardware address of the IPDS port. n can be
n
from 0 to 6.
Notes:
1. SCS ADDR and IPDS ADDR cannot be set to the same
2. If you change SCS ADDR or IPDS ADDR, you must
3. When the IPDS SIMM is installed, the printer can act as
OFF*
Turns edge-to-edge printing on or off.
ON
v OFF—the printer maintains a no-print border of 4 mm on
v ON—The printer allows printing up to the physical page
Notes:
1. To avoid toner contaminating the printer, IBM
2. The Twinax Setup Menu item EDGE-EDGE applies to
value.
power off the printer, wait ten seconds, and then power
on the printer for the new value to take effect.
two separate printers on the same twinax port. (The
printer cannot be attached to two different twinax
systems using the same twinax card.) One "printer"
prints SCS data to one address (SCS ADDR), and the
other prints IPDS to another address (IPDS ADDR).
value.
power off the printer, wait ten seconds, and then power
on the printer for the new value to take effect.
two separate printers on the same twinax port. (The
printer cannot be attached to two different twinax
systems using the same twinax card.) One "printer"
prints SCS data to one address (SCS ADDR), and the
other prints IPDS to another address (IPDS ADDR).
all four paper sides.
size.
recommends leaving EDGE-EDGE set to OFF for twinax
printing; use ON only when necessary.
SCS data only. To specify edge-to-edge printing for IPDS
data, use the EDGE-EDGE item on the IPDS Menu.
Description
Chapter 6. Operator Panel Menus
137
Advertisement
Table of Contents
