Setting Up The Printer; Unpacking The Printer - IBM Infoprint 6700 Series User Manual

Chapter 1

Setting Up The Printer

Setting Up The Printer

Unpacking The Printer

The printer is shipped in a carton and protective bag. The top lid of the carton
has instructions for removing the internal packing material. Keep all packing
material in case repacking is required.
ATTENTION
Avoid touching the electrical connectors to prevent electrostatic
discharge damage while setting up the printer. The discharge of
accumulated electrostatic energy can damage or destroy the printhead
or electronic components used in this device.
ATTENTION
Do not place the printer on its backside during unpacking or handling,
because you may damage the printer interface connector.
Frame
1. Remove the tape strips from the media cover. Lift open the media cover.
2. Remove the tape securing the foam pad to the inside of the media cover.
3. Remove the foam pad between the front door and the frame.
32
Foam Pads (2)
Tape Strips (2)
Media Cover