Table of Contents
Advertisement
Token Ring Menu
Item
BOOTP
DHCP
NETWARE
NW FRAME
Value
IFNO ADDR*
Specifies whether the token-ring network interface card
ON
sends BOOTP requests to the server to have an IP address
OFF
assigned to the printer.
v IFNO ADDR—specifies that the token-ring network
v ON—specifies that the token-ring network interface card
v OFF—specifies that the token-ring network interface card
Notes:
1. This menu item appears only when TCP/IP is ON.
2. The number of BOOTP requests is determined by a
IFNO ADDR*
Specifies whether the token-ring network interface card
ON
sends DHCP requests to the server to have an IP address
OFF
assigned to the printer.
v IFNO ADDR—specifies that the token-ring network
v ON—specifies that the token-ring network interface card
v OFF—specifies that the token-ring network interface card
Notes:
1. This menu item appears only when TCP/IP is ON.
2. The number of DHCP requests is determined by a
ON*
Turns Netware communications on or off.
OFF
v ON—enables Netware communications.
v OFF—disables Netware communications.
AUTO*
Selects the Netware frame type.
802.2
v AUTO—the printer uses the frame type of the first frame
SNAP
v 802.2—the printer uses the IEEE 802.2 frame type.
v SNAP—the printer uses the SNAP frame type.
Note: This menu item appears only when NETWARE is
ON.
interface card sends BOOTP requests only if the address
is not already set at the printer.
sends BOOTP requests.
should not send BOOTP requests.
setting on the token-ring network interface card; the
default is three.
interface card sends DHCP requests only if the address is
not already set at the printer.
sends DHCP requests.
should not send DHCP requests.
setting on the token-ring network interface card; the
default is three.
it receives.
Description
Chapter 6. Operator Panel Menus
123
Advertisement
Table of Contents
