August 24, 2004
Chapter 2. Installation instructions
| |
| |
| |
Unpacking the printer
© Copyright IBM Corp. 1997, 2004
. . . . . . . . . . . . . . . . . . . . . . . 25
USB selection . . . . . . . . . . . . . . . . . . . . . . . . . 33
Before installing an IBM SureMark printer, be sure to read "Electronic emission
notices" on page 195.
DANGER
To avoid a shock hazard, do not connect or disconnect any cables
or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
DANGER
To avoid shock hazard:
The power cord must be connected to a properly wired and
earthed receptacle.
Any equipment to which this product will be attached must also
be connected to properly wired receptacles.
Note: For translations of these safety notices, see IBM Safety Information - Read
This First, GA27-4004.
Note: Save all packing material and shipping containers.
1. Remove the SureMark printer from the shipping container and place it on a flat
surface.
2. Open any shipping containers of additional options and accessories to install
with the SureMark printer.
3. Carefully remove any remaining packing material and packing tape.
. . . . . . . . . . . . . 25
. . . . . . . . . . . . . 29
. . . . . . . . . . . . 32
. . . . . . . . . . . . . . . . . . . . 33
17