Removing The Bezel - IBM 8649 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

Removing the bezel

When working with some devices, such as additional optical drives, you must first
remove the bezel to access the device.
Complete the following steps to remove the bezel:
1. Remove the side cover ("Removing the bezel").
2. For hot-swap hard disk drive models:
3. Locate the bezel-release lever; then, press the bezel-release lever toward the
4. Pull the top of the bezel away from the chassis; then, push the bezel down to
5. Remove the bezel from the server and store the bezel in a safe place.
For instructions for replacing the bezel, see "Replacing the bezel" on page 66.
a. Open the server door.
b. Rotate the hot-swap lock bar forward and remove it from the bezel (see the
illustration on page 47). If the hot-swap lock bar will not rotate, press the top
of the hot-swap lock bar to release the lock mechanism.
front of the server.
disengage the bottom tabs.
Chapter 4. Installing options
37