Non-Hot Swap Power Supply; System Reliability Considerations - IBM 8649 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

Non-hot swap power supply

Before you begin:
v Read "Safety information" on page 129
v Review the information in "System reliability considerations" on page 33
To remove the non-hot-swap power supply, do the following:
1. Turn off the server, if it is on.
2. Unplug the server, and disconnect the power cord; then, disconnect all external
3. Remove the cover. See "Removing the side cover" on page 36
4. Remove the frame-support bracket. See "Removing and installing the support
5. Disconnect internal cables from the system board and drives.
6. Remove the screws from the rear of the server.
7. Gently move the power supply away from the chassis and lift it out of the
cables.
bracket" on page 38
server.
Chapter 5. Field replaceable units
81