IBM 8649 - Eserver xSeries 225 Maintenance And Troubleshooting Manual page 86

10. Place a screwdriver against the bottom release latch of the power button and
11. Gently pinch together the upper release latches and slide the latches through
To replace the power button, complete the following steps:
1. Thread the power button and LED panel cables through the aperture in the
2. Connect the power button and LED panel cables to the power button and LED
3. Press in on the tab on the left side of the panel; then, squeeze the top and
4. Press in on the drive-cage release tab, and rotate the drive cage back into the
5. Connect the SCSI signal cable to the SCSI backplane.
6. Replace the hot-swap hard disk drives. See "Installing a hot-swap hard disk
7. Replace the front bezel. See "Replacing the bezel" on page 66
8. Install the side cover. See "Replacing the side cover" on page 67
9. Connect external cables and the power cable, and turn on the server.
76
IBM xSeries 225 Types 8649: Hardware Maintenance Manual and Troubleshooting Guide
9. Note where the power-switch and LED panel cables connect to the system
board; then, carefully disconnect the cables from the system board.
Notes:
a. You might need to remove the diskette, SCSI, and IDE cables to access
the power switch and LED panel cable connector.
b. Some cables might have two connectors for you to disconnect.
c. See the system service label for system board connector locations.
gently press upward and slide the latch through the aperture.
the aperture and remove the power button.
chassis and bottom release latch.
panel connectors on the system board.
bottom of the right side of the panel and carefully push the panel into place in
the aperture in the chassis.
server.
drive" on page 47