Installing The Additional Microprocessor - IBM 8649 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

10. If the configuration shown in the wizard is satisfactory, click Next to save the
11. Click Finish to complete the process.
12. Click Yes to restart the server.
13. Continue with step 1 of "Installing the additional microprocessor."

Installing the additional microprocessor

The following illustration shows how to install an additional microprocessor.
Complete the following steps to install an additional microprocessor:
58
IBM xSeries 225 Types 8649: Hardware Maintenance Manual and Troubleshooting Guide
6. In the Advanced Configuration and Power Interface (ACPI) PC Properties
window, click the Driver tab; then, click Update Driver.
7. In the Update Device Driver Wizard window, click Next.
8. In the next window, click Display a list of known drivers for this device so
that I can choose a specific driver; then, click Next.
9. In the next window, click Show all hardware of this device class. From the
Models list, select ACPI Multiprocessor PC; then, click Next.
configuration.
Microprocessor
baffle
Microprocessor 2
Heatsink 2
Captive screws
1. Review the safety information beginning on page 129 "Installation guidelines"
on page 33, and "Handling static-sensitive devices" on page 34.
2. Turn off the server and all attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the side cover (see "Removing the side cover" on page 36).
5. Remove the support bracket ("Removing and installing the support bracket" on
page 38).
6. Remove the adapter airflow guide:
a. Rotate the front and rear adapter-retention brackets to the open (unlocked)
position.
Microprocessor
release lever
DIMMs