Default Physical Ethernet Settings - Cisco N5010P-N2K-BE Software Configuration Manual

Displaying Interface Information
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
The following example shows how to display a brief interface status (some of the output has been
removed for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet
Interface
--------------------------------------------------------------------------------
Eth1/1
Eth1/2
Eth1/3
Eth1/4
Eth1/5
Eth1/6
Eth1/7
...
The following example shows how to display the link debounce status (some of the output has been
removed for brevity):
switch# show interface debounce
--------------------------------------------------------------------------------
Port
--------------------------------------------------------------------------------
...
Eth1/1
Eth1/2
Eth1/3
...
The following example shows how to display the CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
Device ID
d13-dist-1
n5k(FLC12080012)
For Release 4.0(1a)N1(1), the default value of the device ID field for CDP advertisement has been
Note
changed from the chassis serial number to the hostname and serial number, as in the example above.

Default Physical Ethernet Settings

The following table lists the default settings for all physical Ethernet interfaces:
Parameter
Debounce
Duplex
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
5-12
VLAN Type Mode Status
200 eth trunk up
1 eth trunk up
300 eth access down
300 eth access down
300 eth access down
20 eth access down
300 eth access down
Debounce time Value(ms)
enable 100
enable 100
enable 100
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Local Intrfce
mgmt0
Eth1/5
Chapter 5
Reason
none
none
SFP not inserted
SFP not inserted
Link not connected
Link not connected
SFP not inserted
Hldtme Capability Platform
148 S I WS-C2960-24TC
8 S I s N5K-C5020P-BA
Default Setting
Enable, 100 milliseconds
Auto (full-duplex)
Configuring Ethernet Interfaces
Speed Port
Ch #
10G(D) --
10G(D) --
10G(D) --
10G(D) --
1000(D) --
10G(D) --
10G(D) --
Port ID
Fas0/9
Eth1/5
OL-16597-01