Displaying And Clearing Ip Acl Statistics; Configuring Mac Acls - Cisco N5010P-N2K-BE Software Configuration Manual

Chapter 20 Configuring ACLs
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Displaying and Clearing IP ACL Statistics

Use the show ip access-lists command to display statistics about an IP ACL, including the number of
packets that have matched each rule. For detailed information about the fields in the output from this
command, refer to the Cisco Nexus 5000 Series Command Reference.
Note The mac access-list is applicable to non-IPv4 and non-IPv6 traffic only.
To display or clear VACL statistics, perform one of the following tasks:
Command
show ip access-lists
clear ip access-list counters
For detailed information about these commands, refer to the Cisco Nexus 5000 Series Command
Reference.

Configuring MAC ACLs

This section includes the following topics:
•
•
•
•
•
•
•
•
OL-16597-01
Creating a MAC ACL, page 20-10
Changing a MAC ACL, page 20-10
Removing a MAC ACL, page 20-11
Changing Sequence Numbers in a MAC ACL, page 20-12
Applying a MAC ACL as a Port ACL, page 20-12
Applying a MAC ACL as a VACL, page 20-13
Verifying MAC ACL Configurations, page 20-13
Displaying and Clearing MAC ACL Statistics, page 20-13
Purpose
Displays IP ACL configuration. If the IP ACL
includes the statistics command, then the show ip
access-lists command output includes the number
of packets that have matched each rule.
Clears statistics for all IP ACLs or for a specific
IP ACL.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring MAC ACLs
20-9