Cisco N5010P-N2K-BE Software Configuration Manual page 74

Initial Configuration
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
when no configuration is present. So setup always assumes system
defaults and not the current system configuration values.
Press Enter at anytime to skip a dialog. Use ctrl-c at anytime
to skip the remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process. Press Ctrl-C at any prompt to end
the configuration process.
Enter the new password for the administrator (admin is the default).
Step 4
Enter the password for admin: admin
Enter yes (no is the default) to create additional accounts.
Step 5
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin
role) besides the administrator's account. See the
information on default roles and permissions.
a. Enter the user login ID.
Enter the user login ID: user_name
Enter the user password.
b.
Enter the password for user_name: user-password
Enter yes (yes is the default) to create an SNMP read-only community string.
Step 6
Configure read-only SNMP community string (yes/no) [n]: yes
SNMP community string: snmp_community
Enter a name for the switch.
Step 7
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 8
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Enter the mgmt0 IPv4 address.
a.
Mgmt0 IPv4 address: ip_address
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended).
Step 9
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IPv4 address.
a.
IPv4 address of the default-gateway: default_gateway
Step 10 Enter yes (yes is the default) to enable the Telnet service.
Enable the telnet service? (yes/no) [y]: yes
Step 11 Enter yes (no is the default) to enable the SSH service.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
3-10
The switch name is limited to 32 alphanumeric characters. The default is switch.
Chapter 3
"Configuring RBAC" section on page 22-5
Configuring the Switch
for
OL-16597-01