Configuring Retransmitting Intervals; About Disabling Fspf For Specific Interfaces; Disabling Fspf For Specific Interfaces - Cisco N5010P-N2K-BE Software Configuration Manual

FSPF Interface Configuration
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Configuring Retransmitting Intervals

To configure the FSPF retransmit time interval, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# interface fc slot/port
Step 3
switch(config-if)# fspf
retransmit-interval value vsan vsan-id

About Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.
FSPF must be enabled at both ends of the interface for the protocol to work.
Note

Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.
To disable FSPF for a specific interface, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# interface fc slot/port
Step 3
switch(config-if)# fspf passive vsan
vsan-id
switch(config-if)# no fspf passive vsan
vsan-id
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
40-8
Chapter 40 Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the retransmit time interval for
unacknowledged link state updates in the specified
VSAN. The default is 5 seconds.
Purpose
Enters configuration mode.
Configures a specified interface, or if already
configured, enters configuration mode for the
specified interface.
Disables the FSPF protocol for the specified interface
in the specified VSAN.
Reenables the FSPF protocol for the specified
interface in the specified VSAN.
OL-16597-01