Deleting Static Vsans; About Load Balancing; Configuring Load Balancing - Cisco N5010P-N2K-BE Software Configuration Manual

Configuring VSANs
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m

Deleting Static VSANs

To delete a VSAN and its various attributes, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# vsan database
switch(config-db)#
Step 3
switch-config-db# vsan 2
switch(config-vsan-db)#
Step 4
switch(config-vsan-db)# no vsan 5
switch(config-vsan-db)#
Step 5
switch(config-vsan-db)# end
switch#

About Load Balancing

Load-balancing attributes indicate the use of the source-destination ID (src-dst-id) or the originator
exchange OX ID (src-dst-ox-id, the default) for load-balancing path selection.

Configuring Load Balancing

To configure load balancing on an existing VSAN, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# vsan database
switch(config-vsan-db)#
Step 3
switch(config-vsan-db)# vsan vsan-id
Step 4
switch(config-vsan-db)# vsan vsan-id
loadbalancing src-dst-id
switch(config-vsan-db)# no vsan vsan-id
loadbalancing src-dst-id
switch(config-vsan-db)# vsan vsan-id
loadbalancing src-dst-ox-id
Step 5
switch(config-vsan-db)# vsan vsan-id
suspend
Step 6
switch(config-vsan-db)# no vsan vsan-id
suspend
Step 7
switch(config-vsan-db)# end
switch#
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
37-10
Chapter 37 Configuring and Managing VSANs
Purpose
Enters configuration mode.
Configures the VSAN database.
Places you in VSAN configuration mode.
Deletes VSAN 5 from the database and switch.
Places you in EXEC mode.
Purpose
Enters configuration mode.
Enters VSAN database configuration submode
Specifies an existing VSAN.
Enables the load-balancing guarantee for the
selected VSAN and directs the switch to use the
source and destination ID for its path selection
process.
Negates the command entered in the previous step
and reverts to the default values of the
load-balancing parameters.
Changes the path selection setting to use the source
ID, the destination ID, and the OX ID (default).
Suspends the selected VSAN.
Negates the suspend command entered in the
previous step.
Returns you to EXEC mode.
OL-16597-01