Cisco N5010P-N2K-BE Software Configuration Manual page 439

Chapter 32 Configuring Fibre Channel Interfaces
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Figure 32-1
Host
Note Interfaces are automatically assigned VSAN 1 by default. See
VSANs."
Each interface has an associated administrative configuration and an operational status:
•
•
The following sections provide a brief description of each interface mode:
•
•
•
•
•
•
E Port
In expansion port (E port) mode, an interface functions as a fabric expansion port. This port may be
connected to another E port to create an Inter-Switch Link (ISL) between two switches. E ports carry
frames between switches for configuration and fabric management. They serve as a conduit between
switches for frames destined to remote N ports. E ports support class 3 and class F service.
An E port connected to another switch may also be configured to form a SAN port channel (see
Chapter 36, "Configuring SAN Port
OL-16597-01
Switch Port Modes
N port
F port
E port
The administrative configuration does not change unless you modify it. This configuration has
various attributes that you can configure in administrative mode.
The operational status represents the current status of a specified attribute such as the interface
speed. This status cannot be changed and is read-only. Some values may not be valid when the
interface is down (for example, the operational speed).
E Port, page 32-3
F Port, page 32-4
NP Port, page 32-4
TE Port, page 32-4
SD Port, page 32-4
Auto Mode, page 32-4
ISL lin k
E port
Channels").
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Information About Fibre Channel Interfaces
F port
N port
Chapter 37, "Configuring and Managing
32-3