Creating Fc Aliases - Cisco N5010P-N2K-BE Software Configuration Manual

Chapter 38 Configuring and Managing Zones
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•
•
The switch supports a maximum of 2048 aliases per VSAN.
Tip

Creating FC Aliases

To create an alias, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# fcalias name AliasSample
vsan vsan-id
Step 3
switch(config-fcalias)# member type
value
Table 38-2
Device alias
Domain ID
FC ID
Fabric pWWN
Local sWWN interface
Domain ID interface
Remote sWWN interface
pWWN
The following example shows how to configure different types of member alias:
switch(config)# fcalias name AliasSample vsan 3
pWWN example:
switch(config-fcalias)# member pwwn 10:00:00:23:45:67:89:ab
fWWN example:
switch(config-fcalias)# member fwwn 10:01:10:01:10:ab:cd:ef
OL-16597-01
Domain ID—The domain ID is an integer from 1 to 239. A mandatory port number of a non-Cisco
switch is required to complete this membership configuration.
Interface—Interface-based zoning is similar to port-based zoning because the switch interface is
used to configure the zone. You can specify a switch interface as a zone member for both local and
remote switches. To specify a remote switch, enter the remote switch WWN (sWWN) or the domain
ID in the particular VSAN.
Type and Value Syntax for the member Command
Purpose
Enters configuration mode.
Configures an alias name (AliasSample).
Configures a member for the specified fcalias
(AliasSample) based on the type (pWWN, fabric
pWWN, FC ID, domain ID, or interface) and value
specified. See
Note Multiple members can be specified on
multiple lines.
member device-alias device-alias
member domain-id domain-id portnumber number
member fcid fcid
member fwwn fwwn-id
member interface type slot/port
member interface type slot/port domain-id domain-id
member interface type slot/port swwn swwn-id
member pwwn pwwn-id
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Table 38-2 for details.
Zone Sets
38-11