Default Login; Configuring The Switch - Cisco N5010P-N2K-BE Software Configuration Manual

Chapter 3

Configuring the Switch

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
If you are using IPv4, be sure to configure the IPv4 route, the IPv4 default network address, and the IPv4
Note
default gateway address to enable SNMP access.

Default Login

The switch has the network administrator as a default user (admin). You cannot change the default user
at any time.
There is no default password so you must explicitly configure a strong password. If a password is trivial
(short, easy-to-decipher), your password configuration is rejected. Be sure to configure a strong
password. If you configure and subsequently forget this new password, you have the option to recover
this password.
If you enter a write erase command and reload the switch, you must reconfigure the default user (admin)
Note
password using the setup procedure.
Configuring the Switch
This section describes how to initially configure the switch.
Note Press Ctrl-C at any prompt to skip the remaining configuration options and proceed with what you have
configured up to that point. Entering the new password for the administrator is a requirement and cannot
be skipped.
If you do not want to answer a previously configured question, or if you want to skip answers to any
Tip
questions, press Enter. If a default answer is not available (for example, switch name), the switch uses
what was previously configured and skips to the next question.
To configure the switch for first time, follow these steps:
Ensure that the switch is on. Switches in the Cisco Nexus 5000 Series boot automatically.
Step 1
Enter the new password for the administrator.
Step 2
Enter the password for admin: password
Tip
Enter yes to enter the setup mode.
Step 3
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup is mainly used for configuring the system initially,
OL-16597-01
If a password is weak (short, easy-to-decipher), your password configuration is rejected. Be sure
to configure a strong password. Passwords are case-sensitive.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Initial Configuration
3-9