Deleting San Port Channels; Interfaces In A San Port Channel - Cisco N5010P-N2K-BE Software Configuration Manual

Interfaces in a SAN Port Channel

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
If you delete the SAN port channel for one port, then the individual ports within the deleted SAN port
channel retain the compatibility parameter settings (speed, mode, port VSAN, allowed VSAN, and port
security). You can explicitly change those settings as required.
•
•

Deleting SAN Port Channels

To delete a SAN port channel, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# no interface san-port-channel
channel-number
The following example shows SAN port channel deletion:
switch(config)# no interface san-port-channel 1
san-port-channel 1 deleted and all its members disabled
please do the same operation on the switch at the other end of the san-port-channel
Interfaces in a SAN Port Channel
You can add or remove a physical Fibre Channel interface (or a range of interfaces) to an existing SAN
port channel. The compatible parameters on the configuration are mapped to the SAN port channel.
Adding an interface to a SAN port channel increases the channel size and bandwidth of the SAN port
channel. Removing an interface from a SAN port channel decreases the channel size and bandwidth of
the SAN port channel.
Virtual Fibre Channel interfaces cannot be added to SAN port channels.
Note
This section describes interface configuration for a SAN port channel and includes the following topics:
•
•
•
•
•
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
36-8
If you use the default On mode to avoid inconsistent states across switches and to maintain
consistency across switches, then the ports shut down. You must explicitly enable those ports again.
If you use the Active mode, then the port channel ports automatically recover from the deletion.
About Interface Addition to a SAN Port Channel, page 36-9
Adding an Interface to a SAN Port Channel, page 36-9
Forcing an Interface Addition, page 36-10
About Interface Deletion from a SAN Port Channel, page 36-10
Deleting an Interface from a SAN Port Channel, page 36-11
Chapter 36 Configuring SAN Port Channels
Purpose
Enters configuration mode.
Deletes the specified port channel, its
associated interface mappings, and the
hardware associations for this SAN port
channel.
OL-16597-01