Port Security Manual Configuration; Wwn Identification Guidelines - Cisco N5010P-N2K-BE Software Configuration Manual

Port Security Manual Configuration

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Table 45-2
Device Connection Request
S2, F11
P4, N4, F5 (auto-learning on)
P4, N4, F5 (auto-learning off)
S3, F5 (auto-learning on)
S3, F5 (auto-learning off)
P1, N1, F6 (auto-learning on)
P5, N5, F1 (auto-learning on)
S3, F4 (auto-learning on)
S1, F3 (auto-learning on)
P5, N3, F3
P7, N3, F9
Port Security Manual Configuration
To configure port security on a Cisco Nexus 5000 Series switch, perform this task:
Identify the WWN of the ports that need to be secured.
Step 1
See the
Secure the fWWN to an authorized nWWN or pWWN.
Step 2
Activate the port security database.
Step 3
Verify your configuration.
Step 4
This section includes the following topics:
•
•

WWN Identification Guidelines

If you decide to manually configure port security, note the following guidelines:
•
•
•
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
45-10
Authorization Results for Scenario (continued)
"Adding Authorized Port Pairs" section on page
WWN Identification Guidelines, page 45-10
Adding Authorized Port Pairs, page 45-11
Identify switch ports by the interface or by the fWWN.
Identify devices by the pWWN or by the nWWN.
If an N port is allowed to log in to SAN switch port F, then that N port can only log in through the
specified F port.
Authorization Condition
Denied 7
Permitted 3
Denied 4
Permitted 3
Denied 4
Denied 2
Denied 7
Denied 7
Permitted 5
Permitted 6
Permitted 6
45-11.
Chapter 45 Configuring Port Security
Reason
P10 is bound to F11.
No conflict.
No match.
No conflict.
No match.
P1 is bound to F1.
Only P1 and P2 bound to F1.
P3 paired with F4.
No conflict.
Wildcard ( * ) match for F3
and N3.
Wildcard ( * ) match for N3.
OL-16597-01