Setting The Delay Time - Cisco N5010P-N2K-BE Software Configuration Manual

Chapter 2 Using the Command-Line Interface
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
fc2/1 is down (SFP not present)
Hardware is Fibre Channel
Port WWN is 20:01:00:05:30:00:8e:1e
Admin port mode is auto, trunk mode is on
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
1 frames input, 128 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
1 frames output, 128 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
0 receive B2B credit remaining
0 transmit B2B credit remaining
The following example shows how you can pass CLI session variable as arguments to a child run-script
command process:
switch# show file bootflash:test1.vsh
show interface $(var1) $(var2)
switch# run bootflash:test2.vsh var1="fc2/1" var2="brief"
`show interface $(var1) $(var2)`
-------------------------------------------------------------------------------
Interface
-------------------------------------------------------------------------------
fc2/1 1 auto on sfpAbsent -- -- -- \

Setting the Delay Time

The sleep command delays an action by a specified number of seconds.
The syntax for this command is sleep seconds.
switch# sleep 30
You will see the switch prompt return after 30 seconds. This command is useful within scripts. For
example, if you create a command script called test-script.
switch# show file bootflash:test-script
discover scsi-target remote
sleep 10
show scsi-target disk
switch# run-script bootflash:test-script
When you execute the test-script command script, the switch software executes the discover scsi-target
remote command, and then waits for 10 seconds before executing the show scsi-target disk command.
OL-16597-01
Vsan Admin Admin Status
Mode Trunk
Mode
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
SFP Oper Oper Port
Mode Speed Channel
(Gbps)
Command Scripts
2-13