Verifying Port-Channel Configuration - Cisco N5010P-N2K-BE Software Configuration Manual

Verifying Port-Channel Configuration

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
To configure the LACP link mode and port priority, perform this task:
Command
Step 1
switch# configure terminal
Step 2
switch(config)# interface type
slot/port
Step 3
switch(config-if)# lacp port-priority
priority
This example shows how to set the LACP port priority for Ethernet interface 1/4 to 40000:
switch# configure terminal
switch (config)# interface ethernet 1/4
switch(config-if)# lacp port priority 40000
Verifying Port-Channel Configuration
To display port-channel configuration information, perform one of the following tasks:
Command
switch# show interface port-channel
channel-number
switch# show system internal clis
feature
switch# show lacp {counters |
interface type slot/port | neighbor |
port-channel | system-identifier}
switch# show port-channel
compatibility-parameters
switch# show port-channel database
[interface port-channel
channel-number]
switch# show port-channel
load-balance
switch# show port-channel summary
switch# show port-channel traffic
switch# show port-channel usage
switch# show port-channel database
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
11-12
Chapter 11
Purpose
Enters configuration mode.
Specifies the interface to configure, and enters the
interface configuration mode.
Configures the port priority for use with LACP. Valid
values are 1 through 65535, and higher numbers have
lower priority. The default value is 32768.
Purpose
Displays the status of a port-channel interface.
Displays enabled features.
Displays LACP information.
Displays the parameters that must be the same among the
member ports in order to join an EtherChannel.
Displays the aggregation state for one or more
port-channel interfaces.
Displays the type of load balancing in use for
EtherChannels.
Displays a summary for the port-channel interfaces.
Displays the traffic statistics for EtherChannels.
Displays the range of used and unused channel numbers.
Displays information on current running of the
EtherChannel feature.
Configuring EtherChannels
OL-16597-01