Mpls; Packet Filters; Changes In Default Behavior And Syntax In Junos Release 10.1 For Ex Series Switches - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

MPLS

Packet Filters

Related Topics

Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches

The following changes in system behavior, configuration statement usage, or
operational mode command usage have occurred since the previous release and
might not yet be documented in the JUNOS Software for EX Series switches
documentation:
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches
MPLS enhancements On EX3200 and EX4200 switches, MPLS supports class
of service (CoS), IP over MPLS, and fast reroute to reroute the label-switched
path in cases of link failure.
IPv6 support for firewall filters on EX3200 and EX4200 switches On EX3200
and EX4200 switches, you can apply match conditions to IPv6 traffic on Layer
3 interfaces, aggregated Ethernet interfaces, and loopback interfaces.
The following are the match conditions applicable to IPv6 traffic:
destination-address , destination-port
, ,
interface next-header packet-length
tcp-established , tcp-flags
The following are the actions and action modifiers applicable to IPv6 traffic:
, ,
accept discard routing-instance
policer .
Enhancement to the interface match condition on EX8200 switches On
EX8200 switches, you can now specify aggregated Ethernet interfaces as match
conditions using the
interface
egress firewall filter with an aggregated Ethernet interface as a match condition
and apply the firewall filter to ports, VLANs, and Layer 3 interfaces.
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series
Switches on page 189
Limitations in JUNOS Release 10.1 for EX Series Switches on page 190
Outstanding Issues in JUNOS Release 10.1 for EX Series Switches on page 193
Resolved Issues in JUNOS Release 10.1 for EX Series Switches on page 196
Errata in Documentation for JUNOS Release 10.1 for EX Series Switches on
page 199
Upgrade and Downgrade Issues for JUNOS Release 10.1 for EX Series Switches
on page 200
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series Switches
, destination-prefix-list
,
source-address
, tcp-initial , and traffic-class
, , ,
analyzer count forwarding-class
match condition. You can configure an ingress or
, icmp-code , icmp-type
, ,
source-port source-prefix-list
, , and
loss-priority
189
,
,