Resolved Issues In Junos Release 10.1 For Srx Series Services Gateways And J Series Services Routers - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

JUNOS 10.1 Software Release Notes
VPNs
WLAN
WXC Integrated Services Module
Resolved Issues in JUNOS Release 10.1 for SRX Series Services Gateways
and J Series Services Routers
The following issues from JUNOS Release 10.1 R2 have been resolved in this release.
The identifier following the description is the tracking number in our bug database.
162
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
attachment unit (MAU) information always propagates as "Unknown".
[PR/480361]
On SRX100 High Memory devices and SRX210 Low Memory devices, dot1x
unauthenticated ports accept Link Layer Discovery Protocol (LLDP) protocol data
units (PDUs) from neighbors. [PR/485845]
For SRX210 High Memory devices, during configuration of access and trunk
ports, the individual VLANs from the vlan-range are not listed. [PR/489872]
On SRX5600 devices, the shared IKE limit for IKE users is not currently enforced.
More users than are specified in the shared IKE limit are able to establish
IKE/IPsec tunnels. [PR/288551]
On SRX210 and SRX240 devices, concurrent login to the device from a different
management systems (for example, laptop or computers) are not supported.
The first user session will get disconnected when a second user session is started
from a different management system. Also, the status in the first user system is
displayed incorrectly as "Connected". [PR/434447]
On SRX Series and J Series devices, the site-to-site policy-based VPNs in a three
or more zone scenario will not work if the policies match the address "any",
instead of specific addresses, and all cross-zone traffic policies are pointing to
the single site-to-site VPN tunnel. As a workaround, configure address books in
different zones to match the source and destination, and use the address book
name in the policy to match the source and destination. [PR/441967]
On SRX210, SRX240 and SRX650 devices, J-Web online Help displays the list
of all the countries and is not based on the regulatory domain within which the
access point is deployed. [PR/469941]
When two J Series devices with WXC Integrated Services Modules (WXC ISM
200s) installed are configured as peers, traceroute fails if
on both peers. [PR/227958]
On J6350 devices, JUNOS Software does not support policy-based VPN with WXC
Integrated Services Modules (WXC ISM 200s). [PR/281822]
redirect-wx is configured