Services Applications - Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note

JUNOS 10.1 Software Release Notes

Services Applications

48
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
Increase in limit to external paths accepted for BGP route target filtering You
can now specify for BGP to accept up to 256 external paths for route target
filtering. Previously, the maximum number that you could configure was 16.
The default value remains one (1). To specify the maximum number of external
paths for BGP to accept for route target filtering, include the
statement at the [edit protocols bgp family route-target]
statement is also supported for BGP groups and neighbors.
[Routing Protocols]
Support for having the algorithm that determines the single best path evaluate
AS numbers in AS paths for VPN routes By default, the third step of the
algorithm that determines the active route evaluates the length of the AS path
but not the contents of the AS path. In some VPN scenarios with BGP multiple
path routes, it can also be useful to compare the AS numbers of the AS paths
and to have the algorithm select the route whose AS numbers match. Include
the statement at the
as-path-compare
routing-options multipath]
[Routing Protocols]
Option to view APPID counters Use the option under
application-identification counter
interface.
[System Basics and Services Command Reference]
Session offloading on Multiservices PICs To enable session offloading on a
per-PIC basis for Multiservices PICs, include the
[edit chassis fpc] hierarchy level.
[System Basics]
Option to clear the "do not fragment" bit To clear the "do not fragment" bit
for IPsec with dynamic endpoints, include the
at the
[edit services ipsec-vpn rule rule-name term term-name then]
[Services Interfaces]
Option to clear tunnel MTU To clear the tunnel MTU, include the
statement at the
[edit services ipsec-vpn rule rule-name term term-name then]
hierarchy level.
[Services Interfaces]
M120 router performance with IDP For M120 routers, the performance number
is 4500 connections per second when IDP is enabled.
[Services Interfaces]
Enhancement to the output of the
output for the show services accounting usage
show services accounting memory
mode commands has been updated to include new fields for use in querying
service PICs.
[System Basics and Services Command Reference]
[edit routing-instances routing-instance-name
hierarchy level.
to view the APPID counters for the specified
session-offload
clear-dont-fragment-bit
show services accounting
, show services accounting status
, and
show services accounting errors
external-paths number
hierarchy level. This
show services
statement at the
statement
hierarchy level.
tunnel-mtu
commands The
,
operational