Juniper JUNOS 10.1 - RELEASE NOTES REV 4 Release Note page 195

Outstanding Issues in JUNOS Release 10.1 for EX Series Switches
[PR/400814]
If an SRE module, RE module, SF module, line card, or Virtual Chassis member
is in offline mode, the J-Web interface might not update the dashboard image
accordingly. [PR/431441]
In the J-Web interface, in the Port Security Configuration page, you are required
to configure when you configure even though configuring an
action MAC limit
action value is not mandatory in the CLI. [PR/434836]
In the J-Web interface, in the OSPF Global Settings table in the OSPF Configuration
page, the Global Information table in the BGP Configuration page, or the Add
Interface window in the LACP Configuration page, if you try to change the position
of columns using the drag-and-drop method, only the column header moves to
the new position instead of the entire column. [PR/465030]
In the J-Web interface, in the OSPF Configuration page (Configuration > Routing
> OSPF), the Traceoptions tab in the Edit Global Settings window does not
display the available flags (tracing parameters). As a workaround, use the CLI to
view the available flags. [PR/475313]
When you have a large number of static routes configured and if you have
navigated to pages other than page 1 in the Route Information table in the J-Web
interface (Monitor > Routing > Route Information), changing the Route Table
to query other routes refreshes the page but does not return to page 1. For
example, if you run the query from page 3 and the new query returns very few
results, the Results table continues to display page 3 and shows no results. To
view the results, navigate to page 1 manually. [PR/476338]
In the J-Web interface, the dashboard does not display the uplink ports when
transceivers are not plugged into the ports. [PR/477549]
An IPv4 static route configured using the CLI might not be displayed when you
select Configure -> Routing-> Static Routing in the J-Web interface. [PR/487597]
When you navigate from the Monitor RIP Information page to the Monitor Route
Information page, the J-Web interface might display an error. [PR/536255]
New Features in JUNOS Release 10.1 for EX Series Switches on page 186
Related Topics
Changes in Default Behavior and Syntax in JUNOS Release 10.1 for EX Series
Switches on page 189
Limitations in JUNOS Release 10.1 for EX Series Switches on page 190
Resolved Issues in JUNOS Release 10.1 for EX Series Switches on page 196
Errata in Documentation for JUNOS Release 10.1 for EX Series Switches on
page 199
Upgrade and Downgrade Issues for JUNOS Release 10.1 for EX Series Switches
on page 200
195
Outstanding Issues in JUNOS Release 10.1 for EX Series Switches